12 MAINTENANCE & SERVICING 12.1 Cleaning & Lubrication
58
Cleaning & Lubrication:
Regular preventative maintenance can maintain your bikes performance
and increase the durability. All of the details mentioned in this section
are based upon normal suggested use. If the bicycle is used for rides
in extreme conditions of rain and snow or on irregular terrain, then
maintenance needs to be performed more regularly.
Whyte Bikes suggest that your bicycle is returned to a Whyte retailer for
a professional inspection and service at least once a year. Please ensure
you follow the recommended service schedule found in this manual.
Cleaning: When cleaning your bicycle there are many methods. Whyte
recommends using a very steady stream of water and avoid using
pressure washers. Pressure washers can force water past sealed joints,
causing premature mechanical wear. Your bicycle must be cleaned with a
soft, damp cloth or sponge. Use a suitable detergent or bike cleaner to aid
removal of grease/oil based products.
Avoid leaving your bicycle out in the weather. When not riding, store your
bike where it will be protected from rain, snow, sun, etc. Rain or snow may
cause the metal on your bicycle to corrode. Ultraviolet radiation from the
sun may fade the paint, or crack any rubber or plastic on the bicycle.
WARNING! Failure or improper maintenance can lead to
performance defects, malfunctions, or imperfections to the
bicycle assembly which could result in serious injury or death.
INFO: Some cleaning products can be damaging to your
bicycle. Harsh chemicals can damage paint, plastics and even
metal components. Please use bike suitable cleaning products
or if in doubt contact your Whyte retailer.
WARNING! Take care when cleaning near disc brakes. Cleaning
products or lubricants that come into contact with the discs
or pads can considerably reduce braking power which could
result in serious injury or death.
INFO: For cleaning and servicing recommendations of bike
parts such as forks, shock, pedals and cranks please consult
the relevant manufacturers manuals.
WARNING! Do not use a steam cleaner or a high pressure
cleaner to clean your eBike. Contact of water and electronics
can destroy the drive unit. Drive units should be cleaned with
a soft rag and neutral detergents. A moist rag can be used
but ensure excessive water is avoided. Do not submerge any
electrical component.
WARNING! Avoid washing your eBike in the upside down
position. By turning the eBike upside down the frame can
no longer drain water or debris. Build up of water and debris
inside the frame can damage electrical components.
To Next Page
