53
10 Range Extender
10.3 Charging
Charging the PowerMore Battery
A Bosch eBike battery of the smart system generation of systems must
only be charged using an original Bosch charger from the smart system
generation of systems.
Note: The eBike battery is supplied partially charged. To ensure full
capacity of the eBike battery, fully charge the battery in the charger
before using it for the rst time.
To charge the PowerMore battery, read and follow the instructions in the
‘Charging’ section of this manual. The eBike battery can be charged at
any state of charge. Interrupting the charging process does not damage
the eBike battery.
Battery Charge Indicator Outside of the eBike
Note: The PowerMore battery charge indicator (2) switches back off as
soon as the eBike battery is switched on. The ve LEDs on the battery
charge indicator (2) show the battery’s state of charge when the eBike
battery is switched on. Each LED represents approximately 20% of the
charging capacity. When the eBike battery is fully charged, all ve LEDs
will be lit.
Laying the Cable on the PowerMore Battery Holder (see Figure A)
Note: When laying the cable (6), make sure that the cable (6) is fed
under the release button (10). This prevents the release button (10) from
being pressed accidentally and causing the PowerMore battery to be
released.
Inserting and Removing the PowerMore Battery
- When inserting the battery into the holder or removing it from the
holder, always switch off the eBike battery and the eBike beforehand.
- Once you have inserted the eBike battery, check that it is correctly
positioned and secure in all directions.
- Only leave the PowerMore battery with the cable connected to the
eBike.
- Once the PowerMore battery is installed, the connection socket of the
battery must not face upwards.
Inserting the PowerMore Battery (see Figure B)
To insert the battery (1), align and slide the guide grooves (12) onto the
guide rails (11). Ensure that the battery is aligned correctly and that the
battery is positioned in both guide rails. Slide the battery (1) into the
holder (9) until it audibly clicks into place. Insert the cable connector (4)
into the connection socket (3). Ensure that the cable connector (4) is
aligned correctly. Insert the cable connector (7) into the eBike charging
socket (8). Ensure that the cable connector (7) is aligned correctly.
Removing the PowerMore Battery (see Figure C)
Firstly, disconnect the cable (6) by opening the cable lock as directed
by the eBike manufacturer. Pull the release mechanism (14) towards you
and remove the cable connector (7) from the eBike charging socket .
Press the release buttons (13) and remove the cable connector (4) from
the connection socket. To remove the battery (1), press the release button
(10) and pull the battery (1) sideways out of the holder (9).
Note: As a result of varying designs, the PowerMore battery may need
to be inserted and removed using a different method. Read the eBike
manufacturer’s operating instructions for how to do this.
1
2
To Next Page