Bosch WNA144V9GB - Detergents and Care Products; Safe Detergent and Care Product Use; Basic Appliance Operation; Switching On and Setting Programmes

Basic operation en
31
13.6 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page30
1. Press ⁠Start/ Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
2. If the display shows , the laundry
is not spun. The water is pumped
out after the rinse cycle.
Notes
¡ If you do not remove the laundry
once the programme has ended,
the crease-reduction function starts
after 15 minutes and takes approx.
30 minutes. The display shows 0：
00， ⁠ ⁠， and End alternately,
and appears.
Press any button on the display to
cancel the crease-reduction pro-
gramme and to remove the laun-
dry.
¡ If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
13.7 Soaking laundry
Note:No additional detergent is re-
quired for soaking. The appliance
uses the filled detergent for soaking
and washing.
Requirements
¡ The laundry is placed in the appli-
ance.
→"Loading laundry", Page30
¡ A programme has started.
→"Starting the programme",
Page31
1. Press ⁠Start/ Reload approx.
10minutes after the programme
start.
The programme pauses and the
laundry can soak.
2. Press ⁠Start/ Reload after the
required soaking time.
13.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press ⁠Start/ Reload.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page22
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press ⁠Start/ Reload.
13.9 Cancelling the washing
programme
1. Press ⁠Start/ Reload.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→"Programmes", Page25
3.
Remove the laundry. →Page32