Fault finding and diagnosis
Greenstar Danesmoor Kitchen
ErP+
and Kitchen System
ErP+ -
6 720 821 686 (2018/04) 59
8.9 Oil appliance commissioning checklist
This Commissioning checklist is to be completed in full by the competent
person who commissioned the appliance as a means of demonstrating
compliance with the appropriate Building Regulations and then handed
to the customer to keep for future reference.
IMPORTANT
▶ Leave this manual with the Homeowner.
Appliance details
Appliance make and model:
Appliance serial number:
Commissioning Engineer Commissioning checks
Company name: Oil type used is Kerosene Yes
Company address: Pump pressure PSI
CO
2
%
CO ppm
CO/CO
2
ratio
Telephone number: Smoke reading
Commissioned by (signature) Flue gas temperature °C
(print name) Flue pressure
Commissioning date: Burner model:
Controls: Tick the appropriate boxes
Time and temperature control to heating Room thermostat and programmer/timer Programmable room thermostat
Load/Weather compensation Optimum start control
Time and temperature control hot water Cylinder thermostat and programmer/timer Combination boiler
Heating zone valves Fitted Not required
Hot water zone valves Fitted Not required
Thermostatic radiator valves Fitted Not required
Automatic by-pass valve fitted to system Fitted Not required
Boiler interlock Provided
All Systems
The system has been flushed and cleaned in accordance with BS7593 and appliance manufacturer’s instructions? Yes
What system cleaner was used?
What inhibitor was used? Quantity litres
Has a system filter been fitted? Yes No
The condensate drain has been installed in accordance with the manufacturer’s instructions and/or BS5546/BS6789? Yes
If the condensate pipe terminates externally has the pipe diameter been increased and weatherproof insulation fitted? Yes
Central Heating mode: Measure and record
Central Heating flow temperature °C Central Heating return temperature °C
Domestic Hot Water mode: Measure and record
Combination boilers only
Is the installation in a hard water area (above 200ppm)? Yes No
If yes, has a water scale reducer been fitted? Yes No
What type of scale reducer has been fitted?
Cold Water Inlet temperature °C Hot Water Outlet temperature °C
Water flow rate l/min
All installations
Fire valve fitted rated to 85 °C. Yes
Is the flue damper correctly fitted? Yes No
Are the hoses from the Air pressure switch correctly routed and free from kinking? Yes No
Is a solid non-combustible surface large enough to accommodate the appliance provided? Yes No
Is the oil tank and supply clean and free from contamination? Yes No
Does the installation comply with current OFTEC Regulation? Yes No
The heating and hot water system complies with the appropriate Building Regulations? Yes No
The appliance and associated products have been installed and commissioned in accordance with the manufacturer’s instructions? Yes No
The operation of the appliance and system controls have been demonstrated to and understood by the customer? Yes No
To Next Page
Loading...
Need help?
General