enSet up and connect
4.5 Connecting the device
ATTENTION!
When pumping out, the water drain
hose is under pressure and can detach
from the installed connection point.
▶ Secure the water drain hose
against unintentional loosening.
water inlet hose
connect
WARNING
Electric shock hazard!
The device contains live parts.
Touching live parts is dangerous.
▶ Do not immerse the electric
Aquastop valve in water.
A notice:Note the pump heights.
The maximum pumping height is 1
The connection
place with one
hose clamp
(24-40 mm)
chern.
A notice:Make sure that you connect
the device to a water supply with a
safety device against drinking water
contamination through backflow
(according to DIN EN 1717). The
connection valves/water taps
provided for this purpose are
equipped with this safety device if the
house is properly installed.
bathroom sink the water
running hose with
a manifold
→
page 28
fix and
secure.
1.Connect the water inlet hose to the
tap (26.4 mm = 3/4").
plastic pipe
with rubber sleeve
or gully
the water
running hose with
a manifold
→
page 28
fix and
secure.
2.Open the tap carefully and check
whether the connection points are
tight.
Connection types water drainage
The information helps
Connect this device to
the Wa.
en you, the-
water flow
16
To Next Page
Loading...
