securityen
1.4 Secure Installation
When installing the device, observe the safety instructions.
WARNING - DANGER OF ELECTRIC SHOCK!
Improper installations are dangerous.
▶ Only connect and operate the device in accordance with the
information on the type plate.
▶ Connect the equipment to an AC power supply only through a
properly installed, grounded outlet.
▶ The protective conductor system of the electrical house installation must
be installed in accordance with the regulations. The installation must have
a sufficiently large cable cross-section.
▶ When using a residual current circuit breaker, only use a type
with the symbol .
▶ Never supply the device via an external switching device, e.g.
B. timer or remote control.
▶ When the device is installed, the mains plug of the mains
connection cable must be freely accessible, or if free access is not
possible, an all-pole separator must be installed in the
permanently installed electrical installation in accordance with the
installation regulations.
▶ When setting up the device, make sure that the power cord
is not pinched or damaged.
Damaged insulation of the power cord is dangerous.
▶ Never bring the power cord into contact with hot parts of the
device or sources of heat.
▶ Never bring the power cord into contact with sharp points or
edges.
▶ Never kink, crush or modify the power cord.
5
To Next Page
Loading...
