Bosch WUU28T41 - Basic Operation; Powering On and Program Selection; Loading Laundry and Detergent

enservice
13.2 Set program
2.Press down the insert and remove
the detergent drawer.
1.Turn the program selector and set it
to the required programme.
→ "programs", page 24
2.If necessary, adjust program
settings → page 30 .
13.3 Customize program
settings
Precondition:A program is set.
→ "Set program", page 30
3.Insert the dosing aid.
▶ Adjust the program settings.
→ "Buttons", page 23
A notice:The program settings are not
saved permanently for the program.
13.4 Load laundry
A notice:To avoid creasing, observe
the maximum load of the
→ "programs", page 24 .
4.Insert the detergent drawer.
Precondition:The laundry is prepared.
→ "Laundry", page 28
13.6 Use dosing aid for liquid
detergent
1.Open the door.
Make sure the drum is empty.
You can use a dosing aid in the
detergent drawer to measure out
liquid detergent.
1.Pull out the detergent drawer.
2.Put the laundry in the drum.
3.Close the door.
Make sure no laundry is caught in
the door.
13.5 Use dosing aid for liquid
detergent
If you use the dosing aid as an accessory
the dosing aidorder, you must
deploy.
1.The Detergent Sch
draw.
drawer out-
30