Set up and connecten
4.6 Align device
3.Hand-tighten the lock nuts against
the housing using a SW17 wrench.
Orient the device correctly to reduce
noise and vibration and to prevent the
device from wandering.
1.Loosen the counter nuts clockwise
with a SW17 wrench.
Hold the base of the device and
do not adjust the height.
4.7 Connecting the device
electrically
2.To align the device, turn the device
feet. Check alignment with a spirit
level.
A notice:Your domestic electrical
installation for this device must
comply with local legal and safety
regulations and should include an
earth leakage circuit breaker.
1.Plug the mains plug of the device's
power cord into a socket near the
device.
The connection data of the device
can be found in the technical data
→
page 52
.
2.Check that the mains plug is firmly
seated.
All device feet must stand firmly
on the floor.
17
To Next Page
Loading...
