enchild lock
13.10 Soaking laundry 13.13 Continue program at
rinse stop
A notice:No additional detergent is
necessary. The suds are then used
for washing.
1.The programSlingor select a suitable
pumping program.
→
"programs", page 24
1.Start the program.
2.To pause the program, open after
about 10 minutesStart/ Reloadto
press.
2.onStart/Reloadto press.
13.14 Remove laundry
3.To continue the program, after the
desired soaking timeStart/Reloadto
press.
1.Open the appliance door.
2.Remove the laundry.
13.11 Add laundry
13.15 Switch off the device
1.onStart/Reloadto press. The
device pauses.
1.Open the program selectorOut of
place.
2.Wipe the rubber boot dry and
remove foreign objects.
A notice:if
It is not possible to add laundry.
appears is
When goes out, it is possible to
add laundry.
2.Open the appliance door.
3.Add or remove the laundry.
4.Close the appliance door.
5.onStart/Reloadto press.
13.12 Cancel program
1.onStart/Reloadto press.
2.Open the appliance door.
3.Leave the appliance door and the
detergent drawer open so that any
residual water can dry off.
When the temperature and water
level are high, the door will remain
locked for safety reasons.
– If the temperature is high, start
the programWash .
– If the water level is high, start the
programSling or select a suitable
pumping program.
→
"programs", page 24
14 Child Lock
Secure your device against
accidental use of the controls.
14.1 Activating child safety
3.Take out the laundry
→
page 32
.
men
▶ On both keys 3 secpress for about
3 seconds.
32
To Next Page
Loading...
