24 December 20, 2001 AM191409_01_V.pdf
Maintaining Your Lifestyle
®
12 System
Changing the house code settings
Each Lifestyle
®
remote control uses a system of matching house codes to communicate with
its corresponding music center. If your remote’s commands ever conflict with those of
another nearby Lifestyle
®
system, you can easily set a new house code for your system and
its remote control(s) by following the procedures below.
1. Open the remote control battery cover.
2. Locate the miniature switches (Figure 22). Change the position of switch 2, 3, or 4 by
moving it in the opposite direction from its current setting.
Note:
Do not change any other switches at this time.
3. Replace the battery cover on the remote control.
4. Press the OFF key on the console.
5. Open the CD cover.
6. Press the STORE key. The display will begin to flash ‘— —’.
7. Within two seconds while the display is flashing, press any key on the remote control.
The display stops flashing and momentarily shows ‘— —’ to confirm recognition of the
house code. The system will remain off.
8. If you have additional remote controls, open the battery cover of each one and change the
switches to match those of the first remote control. It is not necessary to repeat steps 4–7.
Figure 22
Miniature switches for setting
house codes and speakers
234
ON
5678
K
40
l
House code switches
To Next Page
Loading...
Need help?
General
