Installers Guide to the Bose® Serial interface June 28, 2011
Bose Confidential Information Page 26/42 Do Not Redistribute
Note there is no response for this command. The Ready packet must be received from the
Console before the Client can send another command.
6.3.1.3 Query Hard Key Press Notification State
Use this command to query the hard key press notification state.
Client sends: 07 00 01 1b 00 00 1d
Table 6-9 Query Hard Key Press Notification State Format
The total number of bytes in this packet is 7
All Status bits must be zero for packets sent by the Client
The OpCode of the query key press notification state
Payload for Key press notification from Client
1d = 0x07 ^ 0x 00 ^ 0x01 ^ 0x1b ^ 0x00 ^ 0x00
Console responds: 05 <Status> 01 1b <M>
Table 6-10 Query Hard Key Press Notification State Response Format
The total number of bytes in this packet is 5
Error bit = 0, Notification bit = 0
The OpCode of the query key press notification state
Key press notification is disabled: <M> = 0
Key press notification is enabled : <M>≠ 0
6.3.2 Soft Key Press Notifications
6.3.2.1 Enabling Soft Key Press Notifications
To enable Key Press Notification packets whenever soft keys on the VideoWave are pressed the
Client sends the following packet:
Client sends: 32 00 04 17 0c 00 00 00 00 00 00 00 00 00 00 00
00 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 2c
Table 6-11 Enable Soft Key Press Notifications Command Format
The total number of bytes in this packet is 50
All Status bits must be zero for packets sent by the Client
The OpCode of the Soft button Echo command
Enable (0x01) the Soft Key echo state
XOR of all preceding bytes in message.
To Next Page
Loading...
Need help?
General
