68
1 2 3 4 5 6 7 8 9
House code switches (1 - 4)
Changing House Codes
1. Changing the house code settings.
If commands given from a remote conflict with those of another nearby media center, the house
code for the media center can be changed as follows.
1.1 Open the remote control battery cover and locate the miniature switches.
1.2 Change the position of the switches 1, 2, 3, or 4 by moving them in the opposite direction
from their current settings. Use a paper clip, ball point pen, or similar object.
Note: Do not change any other switch settings. Moving other switches may cause the remote to
not control the media center.
1.3 Replace the battery cover.
1.4 Lift the media center door and press the All Off button.
1.5 Press and hold the Store key. The current house code will appear in the media center display
in the form of four rectangles which represent the positions of switches 1 through 4.
HOUSE CODE:
Current house code = 0000
(Switches 1 - 4 down.)
1.6 While holding the Store key, press any key on the remote control. The display will change to
show the new house code confirming recognition of the new code.
HOUSE CODE:
Current house code = 1010
(Switches 1 up, 2 down, 3 up, 4 down.)
1.7 Release the Store key, the system remains off.
1.8 Using the remote, turn the AV28 media center on
and then off. This will complete the process of storing
the new house code.
Figure 7. House Code Settings
To Next Page
Loading...
Need help?
General
