6
This FreeSpace
®
6 business music system installer’s guide consists of the following sections:
System Placement This section aids you in determining where to place the loud-
speakers, the remote control unit, and the system electronics.
System Installation This section explains how to assemble and install the flush-
mount loudspeakers, the surface-mount loudspeakers,
the system electronics, and the remote control unit.
System Setup This section explains how to set the different zones on the
FreeSpace 6 system. A troubleshooting table and the product
specifications are included at the end of this section.
The following additional information is available free upon request. Bose
®
can either fax it or mail it to you. Just
call 1-800-996-2673 (in the United States and Canada) or your local Bose distributor and request the information
by name and part number.
Balanced and Unbalanced This five-sheet packet offers guidelines for wiring to and from
Source Terminals (PN183072) the system electronics and has many illustrations showing the
correct wiring configurations for balanced and unbalanced
setups.
Loudspeaker Painting (PN183073) This two-sheet packet contains a recipe for mixing paint and
instructions for applying that paint to the grille and rim of the
flush-mount loudspeakers.
Radio Frequency Interference This sheet suggests ways to determine the source of the
and Hum (PN183074) interference and ways to correct it.
System Components (PN183076) This four-sheet packet explains the 13 zones in the FreeSpace 6
business music system. It also offers information on how to
choose a microphone.
Wire Considerations (PN183078) This sheet discusses the recommended class of wire to use per
UL and CSA standards.
Introduction
English
AM180090_02_V.pdf • May 7, 2002
To Next Page
Loading...
Need help?
General
