EasyManuals Logo

Bose L1 model 1S system User Manual

Bose L1 model 1S system
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14
SYSTEM SETUP
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands ItalianoSvenska DeutschNederlands Français Español
Adding a second B1 bass module (optional)
The bass module output of the power stand can adequately drive one or two B1 bass
modules. When placed horizontally, the modules are stackable (Figure 7).
CAUTION:
Do not connect more than two B1 bass modules to the Bass Module Out
connector on the power stand. Driving more than two B1 bass modules from this output
improperly loads the amplifier in the power stand, resulting in less than full system performance.
1. Connect the first B1 to the Bass Module Out co
nnector on the power stand.
2. Plug one end of the second B1 cable into the unused connector of the first B1. Plug the
other end o
f the cable into one of the connectors of the second B1.
Figure 7
Installation of two B1 bass
modules
Second B1
bass module
cable
First B1 bass
module cable
Bass Module Out
VeniceOG.book Page 14 Monday, April 30, 2012 2:33 PM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bose L1 model 1S system and is the answer not in the manual?

Bose L1 model 1S system Specifications

General IconGeneral
BrandBose
ModelL1 model 1S system
CategoryAmplifier
LanguageEnglish

Related product manuals