Bose LIFESTYLE 535 - Page 50

Care and Maintenance
Problem
What to
do
Sound quality has Press the Setup button on the control console and select the
changed and speaker
"Reconnect
Acoustimass" menu item.
Follow the onscreen
array status indicator instructions.
is blinking orange (135
series
II
systems only).
TV
does not respond to
• Make sure the speaker array is not blocking
theIR
sensor on
remote commands the
TV.
Change the position
of
the
TV
and speaker array so
(135 series
II
systems that
theIR
sensor is not blocked.
only)
•
For details on the location
of
the TV's
IR
sensor, refer to the
owner's guide that came with your
TV.
Intermittent bass
•
Check that the status indicator on the Acoustimass® module
(135 series
II
systems is orange and not blinking.
only)
• If
the speaker array status indicator is blinking orange:
-Check
that the Acoustimass module is plugged into a
live
AC
wall outlet and the status indicator is glowing orange.
- Press the Setup button on the control console and select
the "Reconnect Acoustimass" menu item.
Follow the
onscreen instructions.
-Try
moving any possible sources
of
wireless interference,
such as a wireless computer network router, another
wireless device, or a microwave oven, further away from
the system.
Sound is impaired by
Contact
Bose®
Customer Service
to
determine if and how
a loud hum or buzz, other electrical devices
in
the room may be creating unwanted
which may be electrical
signals, and
to
obtain possible remedies.
in
nature
Radio does not work
•
Make sure antennas are connected properly.
• Move AM antenna at least
20
inches
(50
em)
from the control
console and Acoustimass module.
•
Adjust antenna position
to
improve reception.
•
Make sure the AM antenna is
in
an
upright position.
• Move antennas farther from control console,
TV,
or other
electronic equipment.
• Select another station.
You
may be
in
an
area
of
weak signal
coverage for some stations.
FM
sound is distorted
•
Adjust antenna position
to
reduce interference.
• Fully
extend the
FM
antenna.
Picture is blurry when
• If
your
30
glasses are
of
the active type, make sure they are
viewing
30
content
turned on.
•
Try changing the
30
system option
to
a different setting.
• If
the problem persists, make sure the speaker array is not
blocking
theIR
sensor on the
TV.
Change the position
of
the
TV
and speaker array so that the
I
R sensor is not blocked.
•
For details on the location
of
the TV's
IR
sensor, refer to the
owner's guide that came with your
TV.
Sound is distorted • Make sure the audio input cable is not damaged and the
connections are secure on both ends.
•
Reduce the volume output
level
from any external devices
connected
to
the control console.
•
(135 series
II
systems only) Remove the protective film from
the trim and
grille
on the speaker array and the front
of
the
Acoustimass module.
28-
English