Bose LIFESTYLE 535 - Resetting the System; Pairing the Remote with the Console

Care
and Maintenance
Problem
Wbaltodo
No sound from a
•
Check the connections.
connected device
• If using a coaxial or optical audio connection, make sure you
have not made both types of connections
to
the same input
on the control console.
•
Make sure that device is turned on.
•
Refer
to
the owner's manual that came with the device.
No
TV
picture, but audio
•
Check the
TV
video input selection. Make sure it is correct for
is heard
the video source.
•
Make sure video cables are securely connected.
A
connected device
Try
connecting the
included
external
lA
emitter to the control
does
not respond
console. For guidance, press the
Setup
button on the control
consistently
to
remote console.
Select
the device options and
follow
the onscreen
commands.
.
instructions.
Intermittent audio drop- Contact Bose Customer Service
to
request a composite video
outs heard on coaxial cable that can be used for the coaxial digital audio connection.
digital audio inputs
Resetting
the
system
1.
Press and
hold
the
Power
button
0 on the control
console for
5
seconds
or until
the system status indicator
on
the control console
changes to red.
The system status indicator on the control console changes to
red
when the
system shuts down.
2.
Release
the
Power
button
0
on
the
control console
to
restart the system.
The system status indicator changes
to
blinking green and then solid green
when the system is on and ready to use.
3.
If
you still
cannot operate the system using the remote, try the next procedure
to pair the remote with the control console.
Pairing
the
remote
with
the
console
You
may need to perform this procedure if you are replacing
a remote or
if
troubleshooting instructions recommend
it.
1.
Make sure your system is on.
If
not, press the
Power
button
0
on the
control console.
2. Hold
the remote
close to the
control console.
3.
Press and
hold
both the
Mute
button
~
on
the
control console and the
OK
button on the remote at the same time for five seconds. The system status
indicator blinks
when pairing
is
complete.
4.
Press any remote button and verify that the system status indicator on the
control console blinks with each button press.
English- 29