34 - ENGLISH
APPENDIX A: INSTALLATION REFERENCE
Connecting an AC-2 adapter
1. Using the screwdriver, turn the screws to the left (counterclockwise) to loosen the
wire terminals.
2. For front speakers: Insert the bare ends of the four-pin cable into the adapter by
placing the red wire marked L+, C+ or R+ into the red terminal ( + ) and the plain
wire into the plain silver terminal ( – ).
For rear speakers: Insert the bare ends of the two-pin cable into the adapter by
placing the red wire marked + into the red terminal ( + ) and the plain wire into the
plain silver terminal ( – ).
Note: Be sure to only insert the bare ends of each exposed wire to avoid clamping
the wire’s insulation.
3. Using the screwdriver, turn the screws right (clockwise) to secure the wires into
the terminals.
4. Repeat steps 1 – 4 to connect the other adapter.
To Next Page
Loading...
