31
6.3 Lift up on the PCB assembly and disconnect
the two wire harnesses that are connected to the
bottom of the board as shown in Figure 14. Tuck
the ends of the wire harnesses back into the
opening covered by the interconnect board as
shown in fi gure 15.
7. Electronics Module Removal
7.1 Perform procedure 5
7.2 Remove the fourteen T10 screws that secure
the electronics module to the MSA12X housing
in fi gure 16.
7.3 Carefully slide the electronics module out
toward either end of the loudspeaker housing as
indicated in Figure 16.
Note: Two black dots indicated by arrows
in Figure 17 are stamped on the MSA12X
enclosure to ensure that the Power Supply is
located in this section of the enclosure during
reinsertion of the electronics module assembly.
Figure 14
Figure 15
Figure 16
Figure 17
DISASSEMBLY PROCEDURE
To Next Page
Loading...
