Installation and Safety Guidelines Page 23
pro.Bose.com Appendix
Fastener technical information:
The following is a list of the fastener sizes that are included with the different RoomMatch™ accessory rigging hardware:
RoomMatch Fastener Size Chart
Part
Name
Metric
Size
Thread
Pitch
Length
(mm)
Class
Marking
Quantity
Included
Full-range module side plates M10 1.5 30 10.9 4
Subwoofer RMSFLY side-plate kit M10 1.5 40 10.9 4
RMAFSM and RMAFLG Array Frames none none none none none
RMXSRT and RMXLNG Extender Bars M10 1.5 120 10.9 4
RMBRKT surface-mount bracket M10 1.5 40 10.9 4
RMPULL bracket M10 1.5 30 10.9 4
Class 10.9 refers to the load rating of the fastener. The “10.9” is always marked on the head of the fastener, as illustrated in the figure
below. Unmarked fasteners or fasteners with a lower class than those listed in the chart above should never be used.
www.pro.bose.com Bose Professional Systems Division
www.adapttechgroup.com Adaptive Technologies Group (ATM Fly-Ware)
www.rigging.net Independent website listing graded fasteners
www.thecrosbygroup.com Supplier of accessories used in the lifting industry
www.cmworks.com Supplier of chain hoists and accessories
www.synaudcon.com Seminars for sound system design and acoustics
www.riggingwarehouse.com Supplier of shackles and other rigging hardware
Sound System Engineering, Third Edition by Don Davis and Eugene Patronis, published by Focal Press (September, 2006), ISBN-13:
978-0240808307
Entertainment Rigging by Harry Donovan, published by SAP (1999). May be purchased direct from www.riggingbooksandprograms.com
Marks’ Standard Handbook for Mechanical Engineers, 11th Edition by Avallone, Baumeister, and Sadegh, published by McGraw-Hill
Professional (November 16, 2006), ISBN-13: 978-0071428675
Note: The resources listed above are available as of September 2011. Bose Corporation makes no representation or warranty regarding
the accuracy, suitability, reliability, or completeness of the information provided in such resources, and disclaims any liability relating to,
or arising from, any party’s use of such information.
To Next Page
Loading...
