SYSTEM CONTROLS
10 - ENGLISH
Touch pad
The system has a touch-sensitive control pad on the front, center
area of the top panel.
Gently tapping the touch pad:
• Powers on or o the system.
• Snoozes an alarm (see page 16).
• Resets an alarm for the next day (see page 16).
Power on the system
There are two ways to power on the system:
Remote control
• Press .
• Press , or to power on the system to the selected
source.
Note: Selecting does not power on a cabled audio device.
Make sure to power on the device first.
Touch pad
Tap the touch pad. The last source you listened to is active.
Standby mode
If the button is not pressed after 24 hours, the system switches to
standby (o). If the 18-minute system standby timer is enabled, the
system automatically switches to standby if no audio is played and
no buttons are pressed for 18 minutes. For more information on
the 18-minute system standby timer see “System Personalization” on
page 20.
If the system is connected to your network when switching to
standby, the connection is maintained.
Adjust the volume
On the remote control:
• Press to increase the volume.
• Press to decrease the volume.
VOLUME - 0 (silent) to 99 (loud) appears on the display to indicate
the level.
When the system is o, the volume can only be adjusted between 10
and 75.
Mute the system
Press to mute or unmute the audio.
Note: While muted, you can press to lower the volume before
unmuting the system.
Messages on the display
Source indicators:
CD, FM, AM, or AUX
Play mode
Clock
Alarm status
Source or system-related information
To Next Page
Loading...
