19
Connecting Other Equipment
English FrançaisEspañol
Using your Wave
®
music system with other audio equipment
When using a TV, VCR, computer, video game or cassette tape player, you can enhance your
listening experience by playing the audio device through your Wave
®
music system.
Connecting an audio device to your Wave
®
music system, requires one of the following cables:
To obtain the correct cable, contact Bose
®
Customer Service or visit a local electronics store.
See the phone numbers listed inside the back cover of this guide.
To connect an audio device, such as your TV, to your Wave
®
music system:
1. Connect one end of the stereo cable to the output of the audio device.
2. Connect the other end of the cable to the AUX IN connector on the rear panel of your
Wave
®
music system.
3. Turn on your Wave
®
music system and the audio device.
4. Press AUX.
5. Press and hold Volume or to adjust the listening level.
Note: If the volume level of your Wave
®
music system cannot be adjusted high enough, try to
increase the volume level of the connected audio device.
Connecting your Wave
®
music system to a Lifestyle
®
system
You can use your Wave
®
music system as a multi-room expansion speaker system for a
Bose
®
link-enabled Lifestyle
®
home entertainment system. Your Wave
®
music system was set
up at the factory for room B. To change this setting, see “Setting the room code” on page 24.
Contact Bose
®
Customer Service to obtain the required cables and instructions. See the
phone numbers listed inside the back cover of this guide.
• Male-to-male 3.5 mm (
1
/8") stereo cable
• Dual RCA male to
3.5 mm (
1
/8") male
stereo cable
Dual RCA male to 3.5mm (
1
/8")
male stereo cable
TV
AUX IN
connector
00.BWMS_UKE.book Page 19 Monday, July 27, 2009 3:49 PM