DIN
rear
mount installation
(uses
factory
radio mounting bracket)
Select a position on
the
head unit
housing where the screw holes
of
the
factory radio bracket align with the
threaded screw holes on sides
of
the
head unit
(Figure 3).
select
two
mounting hole positions on
each side
of
head unit
Figure
3. Select mounting holes
Insert screws in
two
such locations
on each side, and tighten securely
(Figure 4).
NOTE:
For
the rear-mount
installation,
do
not
use the trim piece,
backstrap
or
mounting case.
use two
mounting screws
on each side
factory mounting
bracket
factory bezel
or
dashboard opening
Figure
4.
Insert screws and tighten
Removing
the
head unit
Should you need
to
remove the head
unit, insert
the
levers supplied with
the head unit into the slots near the
left and right ends
of
the faceplate as
shown in
the
drawing until you feel a
"click."
You
can
now
use the levers
to
pull the unit from the dashboard
(Figure 5).
Figure
5 Insert levers until "click" occurs, then use
levels
to
pull
out
head unit.
755081 User's Manual - page 3
To Next Page
Loading...
