Need help?Do you have a question about the Boss BF-3 and is the answer not in the manual?
General| Effect Type | Flanger |
|---|---|
| Control Knobs | Manual, Depth, Rate, Resonance |
| Bypass | Buffered |
| Input Impedance | 1 M ohm |
| Output Impedance | 1 k ohm |
| Recommended Load Impedance | 10 k ohms or greater |
| Modes | Standard, Ultra, Gate/Pan |
| Power Supply | 9V DC, 9V Battery |
| Dimensions | 73 x 129 x 59 mm |
| Current Draw | 40mA |
| Connectors | Input, Output, DC In |
Enhances sound breadth and provides a deep, three-dimensional rotation effect.
Introduces a new mode for a more intense flanging effect.
Offers slicer effect in mono and 3D panning in stereo.
Allows applying the flanger effect precisely when desired.
Enables setting the RATE to the tempo by pressing the pedal.
Connection point for the optional AC adaptor.
Shows effect status, tempo, and battery level.
Connects to amplifiers or other effects units.
Accepts input signals from a guitar.
Accepts input signals from a bass guitar.
Used for switching effects on/off and inputting tempo.
Allows opening the pedal to change the battery.
Adjusts the center frequency of the effect.
Adjusts the amount of resonance or feedback.
Controls the sweep depth of the flanging effect.
Adjusts the speed of the flanging effect.
Selects the flanger effect and pedal mode.
Depress the pedal switch to activate the effect.
Use the MODE knob to choose the desired effect mode.
Adjust the RATE knob for desired effect speed.
Use the DEPTH knob to control effect intensity.
Adjust the MANUAL knob for the effect's center frequency.
Turn the RES knob to adjust the effect's strength.
Setting tempo when the effect is active (CHECK indicator red).
Setting tempo when the effect is inactive (CHECK indicator off).
Loosen the thumbscrew and lift the pedal to access the battery.
Disconnect the old battery and its cord.
Connect the snap cord to the new battery and place it.
Slip the coil spring and close the pedal.
Insert and fasten the thumbscrew securely.
Addresses issues related to the unit not powering up.
Diagnoses why the CHECK indicator is not illuminated.
Troubleshoots issues with sound output or volume levels.
Helps resolve problems with distorted audio output.
Addresses problems with setting the tempo using the pedal.
Resolves issues where tempo input is not synchronized correctly.
Recommended settings for a standard flanger sound on guitar.
Recommended settings for a stereo flanger sound on guitar.
Recommended settings for an intense ultra flanger sound on guitar.
Recommended settings for a rotary flanger sound on guitar.
Recommended settings for a gate flanger sound on guitar.
Recommended settings for a tremolo flanger sound on guitar.
Recommended settings for a chorus-like sound on guitar.
Recommended settings for a fixed flanging sound on guitar.
Recommended settings for strong flanging on bass.
Recommended settings for a vibrato sound on bass.
Recommended settings for a deep flanger sound on bass.
Recommended settings for a slicer sound on bass.
To Next Page
