Boss LS-2 User Manual

HIOPERATION
(DSelect the desired mode.
* Be sure to select an appropriate mode referring to "Mode
Description” and “LS-2 Sample Settings”.
@Connect the relevant units depending on the mode you have
selected.
* Before connecting or disconnecting cords, be sure to turn
down the volume on the amplifier.
(3)Select the desired line by pressing the pedal. Then adjust
the output level of each line with the Level Control Knobs.
* The Level Control Knobs may not work depending on how
the units are set up.
A—O B—
O MODE ,5.
r LEVEL — A@BYPASS, @
Be BYPASS
(ee
ByPaSsSe @
A+B eal e
e e e e e
BYPASS
~CO +20 ~CO +20 OUTPUT SELECT
€ SEND — EJ— RETURNG@
M@ BATTERY REPLACEMENT
@Loosen the thumb screw on the pedal
Use one 9-volt battery
to open It.
(Take out the battery from the battery
housing and disconnect the battery
snap.
(3)Connect a new battery to the battery
snap, then replace the battery in to the
battery housing.
* Make sure that the polarity of the
battery is correct.
()Push the coil spring into the spring
base on the rear of the pedal,then
close the pedal.
* Make sure that the snap cord is not
caught in the pedal or coil spring. Battery
Snap
(Insert the thumb screw into the guide
bush hole and firmly tighten” the
screw.
Battery Snap Cord
Pedal
_— Thumb Screw
A—O B—O
rLEVEL —
MODE ju,
Ae BYPASS, e
B« BYPASS »
eke:
BYPASS¢ ®
A+B ee e
+ . ‘ ‘ BYPASS é
-0O +20 OUTPUT SELECT
~cCO +20
€ SEND — ZY- RETURN@
@ IMPORTANT NOTES
@ To place the LS-2 in the BOSS Carrying Box
BCB-6, you need to attach the supplied
rubber feet to the BCB-6 shown below.
Supplied
Rubber
Foot
Coil Spring BCB-6——
— Guide
Bush
Hole @Remove the battery whenever the unit
Battery is not going to be used for an
Housing extended period of time.
@When operating solely on a battery,
the unit's indicator becomes dim
when the battery is depleted. Replace
the battery immediately.
@if there is a battery in the unit while
an AC adaptor ts being used, normal
operation will continue should the fine
voltage be interrupted (power black-
out) or the power cord become dis-
connected.
@Should a maltunction occur {or if you
suspect there is a problem) dis-
continue use immediately. Contact
qualified service personnel as soon as
possible.
@OUT:9VDC 200mA

Boss LS-2 Specifications

General

Type	Line Selector
Bypass Switching	Buffered Bypass
Power Supply	9V DC
Connectors	1/4" Input/Output Jacks
Accessories	Owner's Manual
Inputs	2 x 1/4" (A, B)
Controls	Mode selector, Level knobs for A and B channels
Dimensions	73mm (W) x 129mm (D) x 59mm (H)
Weight	420g (excluding battery)