Panel Descriptions
Precautions When Connecting
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
* Raise the amp volume only after turning on the power to all connected devices.
* When operating on battery power only, the unit’s indicator will become dim when battery power gets too low. Replace the battery as soon as possible.
* When connection cables with resistors are used, the volume level of equipment connected to the INPUT jacks may below. If this happens, use connection cables that do not contain
resistors.
Caution When Connecting an External Footswitch
You must power off the unit before connecting an external footswitch. If you connect the footswitch while the power is on, recorded data might be lost.
Turning On the Power
Inserting a connecting plug into the OUTPUT A jack turns on the power to the unit.
Once the connections have been completed, turn on the power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or
damage to speakers and other devices.
When powering up: Turn on the power to your guitar amp last.
When powering down: Turn off the power to your guitar amp first.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power-up is required before the unit will operate normally.
* Before turning the unit on/off, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when switching the unit on/off. However, this is
normal and does not indicate a malfunction.
Caution when turning off the power
Never turn off the power while the LOOP indicator is rotating or blinking (i.e., don’t pull the plug out of the OUTPUT A jack). The recorded data might be lost if you do so.
Basic Operation
To perform recording, overdubbing, and playback, press the pedal as shown in the diagram.
To Next Page
Loading...
