To Next PageTo Next Page
Need help?Do you have a question about the Bostitch HP118K and is the answer not in the manual?
General| Depth Adjustment | No |
|---|---|
| Sequential or Contact Trip Trigger | Contact Trip |
| Power Source | Pneumatic |
| Operating Pressure | 70-90 psi |
| Air Inlet | 1/4\" NPT |
Covers general safety warnings and attention points at the beginning of the manual.
Details eye protection conforming to ANSI specifications for safe tool operation.
Addresses requirements for hearing and head protection in specific environments.
Covers safe handling practices, avoiding horseplay, and trigger safety.
Provides dimensions and weight for the HP118K model.
Details fastener series, gauge, range, and magazine capacity.
Specifies air fitting type, recommended operating pressure, and air consumption.
Details on connectors, hoses pressure ratings, and proper air supply sources.
Information on required pressure regulators and maximum operating pressure limits.
Explains the importance of air filters for tool performance and maintenance.
Recommendations for lubricants and precautions for cold weather use.
Safety precautions to avoid injuries during the loading process.
Step-by-step instructions for loading fasteners into the tool magazine.
Emphasizes reading and understanding manual warnings before use.
Explains the sequential operation of the primary and secondary triggers.
Describes the two orientations (open/closed) of the belt hook for hanging the tool.
Instructions for re-orienting the belt hook assembly for left-handed operation.
Step-by-step guide to safely clear jammed fasteners from the tool.
Procedures to verify correct primary and secondary trigger functionality.
Additional safety guidelines for proper and safe tool usage.
Addresses causes and corrections for air leaks from the trigger valve.
Covers causes and corrections for air leaks from the tool frame or nose.
Troubleshoots issues where the tool fails to operate or cycle correctly.
Identifies causes for reduced power or slow cycling of the tool.
Addresses problems with fasteners not feeding consistently or skipping.
Troubleshoots and provides corrections for fasteners jamming in the tool.
Recommends using genuine BOSTITCH replacement parts for optimal performance.
Guidance on cleaning and lubricating parts during seal assembly.
Discusses the impact of air volume and pressure on tool performance.
Instructions for removing the trigger valve assembly from the tool.
