To Next PageTo Next Page
Need help?Do you have a question about the Bostitch MIIIFN and is the answer not in the manual?
General| Type | Finish Nailer |
|---|---|
| Power Source | Pneumatic |
| Fastener Length | 1-1/4" to 2-1/2" |
| Magazine Capacity | 100 |
| Operating Pressure | 70-120 PSI |
| Depth Adjustment | Yes |
| No-Mar Tip | Yes |
| Fastener Gauge | 16-gauge |
| Tool Type | Nail Gun |
Details on fastener types, crown width, wire size, and max length for MIIIFS and MIIIFN models.
Specifies the required air fitting type and inside diameter for the tool, emphasizing free airflow.
Recommends operating pressure range for optimal performance and warns against exceeding it.
Outlines the tool's air consumption rate and how to calculate required air for different usage speeds.
Instructions for selecting and installing the correct male plug for the tool's air supply.
Requirements for air hoses, including working pressure rating and quick disconnecting fittings.
Specifies using only clean, regulated compressed air and warns against incompatible gases.
Details the requirement for a pressure regulator and the maximum allowable air pressure.
Advises on maintaining optimal operating pressure and the impact of pressure drops.
Explains the importance of air filters for tool performance and maintenance.
Recommendations for cold weather operation, including lubricant choices and storage precautions.
Step-by-step instructions for loading staples into the MIIIFS model.
Step-by-step instructions for loading nails into the MIIIFN model.
Emphasizes reading warnings and referring to tool specifications before use.
Recommendation to use genuine Stanley-Bostitch replacement parts for optimal performance.
Detailed steps for lubricating and assembling seals and O-rings during repair.
Discusses the importance of adequate air volume and pressure, and troubleshooting supply issues.
Specific troubleshooting steps for coil nailer issues like skipping fasteners and jamming.
Instructions for disassembling and replacing the piston in the tool.
Steps for removing and replacing the driver blade, including side play adjustment.
Procedure for replacing the piloted valve seals, O-rings, and related components.
Instructions for separating the magazine and replacing the wear plate or blade guide.
Steps for removing and replacing the wear plate and driver guide on the MIIIFN model.
Procedure for removing and replacing the pusher spring assembly in the magazine.
