Bostitch MIIIFS User Manual

BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TO
UNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE
INSTRUCTIONS WITH THE TOOL FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS,
CONTACT YOUR STANLEY-BOSTITCH REPRESENTATIVE OR DISTRIBUTOR.
ANTES DE OPERAR ESTA HERRAMIENTA, TODOS LOS OPERADORES DEBERÁN ESTUDIAR
ESTE MANUAL PARA PODER COMPRENDER Y SEGUIR LAS ADVERTENCIAS SOBRE SEGURI-
DAD Y LAS INSTRUCCIONES. MANTENGA ESTAS INSTRUCCIONES CON LA HERRAMIENTA
PARA FUTURA REFERENCIA, SI TIENE ALGUNA DUDA, COMUNÍQUESE CON SU REPRESEN-
TANTE DE STANLEY-BOSTITCH O CON SU DISTRIBUIDOR.
LIRE ATTENTIVEMENT LE PRÉSENT MANUEL AVANT D’UTILISER L’APPAREIL. PRÉTER UNE
ATTENTION TOUTE PARTICULIÈRE AUX CONSIGNES DE SÉCURITÉ ET AUX AVERTISSE-
MENTS. GARDER CE MANUEL AVEC L’OUTIL POUR FUTUR RÉFÉRENCE. SI VOUS AVEZ DES
QUESTIONS, CONTACTEZ VOTRE REPRÉSENTANT OU VOTRE CONCESSIONNAIRE
STANLEY-BOSTITCH.
OPERATION and MAINTENANCE MANUAL
MANUAL DE OPERACIÓN Y DE MANTENIMIENTO
MANUEL D’INSTRUCTIONS ET D’ENTRETIEN
MIIIFS / MIIIFN
FLOORING TOOLS
HERRAMIENTAS DE PISOS
CLOUEURS DE PLANCHER
103697REVD 5/99
BOSTITCH
®
BOSTITCH
®
Stanley Fastening Systems

Bostitch MIIIFS Specifications

General

Brand	Bostitch
Model	MIIIFS
Category	Tools
Language	English

Summary

Safety Instructions

Eye Protection Requirements

Mandatory ANSI-compliant eye protection with frontal and side protection against flying particles.

Air Supply and Connections

Air Supply Warnings

Do not use oxygen, combustible gases, or bottled gases; do not exceed 200 P.S.I. supply.

Tool Operation and Maintenance Basics

Loading Procedures

Instructions for safely loading fasteners and handling the tool to prevent accidental actuation.

General Operation Guidelines

Tool and Fastener Specifications

Model Specifics

Fastener Compatibility

Air Supply Requirements

Details air fitting, recommended operating pressure (70-90 p.s.i.), and air consumption.

Tool Operation Details

Before Operating

Read and understand manual warnings and identify the operating system on your tool.

Safe Operation Practices

Use tool only as designed, never towards users, never as a hammer, carry by handle.

Maintaining the Pneumatic Tool

Assembly Procedure for Seals

Air Supply-Pressure and Volume

Trouble Shooting

Common Problems and Solutions

Lists common issues like leaks, failure to cycle, lack of power, and jamming with causes and corrections.

Maintaining Specific MIII Series Tools

Replacing Piston and Driver

Step-by-step guide for replacing the piston and driver blade assembly.

Replacing Piloted Valve Seals