14
OK ESC CHANGE
• Select mode100 or mode255 by UP/DOWN buttons.
• Press “RECORD” to confirm your operation, use “ESC” to cancel or exit.
7. 7 MIDI channel
• Enter the setting mode and choose 5. MIDI CH. , then press RECORD button to
enter the relevant further operation. LCD will show you:
MIDI CH. <××>
OK ESC CHANGE
• Select relevant MIDI channels(1-16) by UP/DOWN buttons.
• Press “RECORD” to confirm your operation, and use “ESC” to cancel or exit.
8 Notice for CF card
• Do not pull out the CF card when being used.
• Power must be assured “on”, when reading or storing to CF card.
• Turn off the power when connect or disconnect CF card with the unit.
• CF
card (32M) can be used only for DC-136, otherwise the data would probably be
missing.
• Outputting of DMX would be stopped during the reading or storing to CF card. And so
does to “ASSIGN CH.” mode.
• CF card may become hot during use. Please observe due caution when removing
memory cards from this device.
• Take good care of the CF card, and keep it in good conditions.
9 MIDI Implementation
This unit can receive and transmit MIDI NOTE information according to the relevant
channels. Please keep the following list for reference.
To Next Page
Loading...
Need help?
General
