What to do if my Bounty Hunter Platinum Metal Detector has no power or sound?
If your Bounty Hunter Metal Detector has no power and produces no sounds, it could be due to a dead battery or a loose connection. Try replacing the battery and checking the connections to ensure they are secure.
Why does my Bounty Hunter Platinum chatter or beep erratically?
Your Bounty Hunter Metal Detector may chatter or beep erratically due to several reasons. It could be caused by using the detector indoors, being near power lines, using two detectors too close together (less than 20 feet apart), a highly oxidized buried object, or environmental electromagnetic interference. To resolve this, use the detector outdoors only, move away from power lines, keep detectors at least 20 feet apart, only dig up repeatable signals, or reduce the sensitivity until the erratic signals cease.
Why does my Bounty Hunter Platinum Metal Detector emit constant low tones?
A constant low tone or constant repeating tones from your Bounty Hunter Metal Detector typically indicates a discharged or incorrect type of battery. Replace the battery, ensuring you use only a 9V alkaline battery.
What to do if my Bounty Hunter Platinum LCD doesn't lock on to one Target-ID or emits multiple tones?
If the LCD on your Bounty Hunter Metal Detector doesn't lock onto one Target-ID or the detector emits multiple tones, it could be due to multiple targets being present or a highly oxidized target. Try moving the coil slowly at different angles or reducing the sensitivity.
General| Frequency | 6.6 kHz |
|---|---|
| Discrimination | Yes |
| Sensitivity | Adjustable |
| Battery Type | 9V |
| Batteries | 1 |
| Display | LCD |
| Depth Indicator | Yes |
| Pinpoint Mode | Yes |
| Adjustable Length | Yes |
| Target ID | Yes |
| Waterproof | Search coil only |
| Type | VLF |
| Intended Use | Coin, Relic, Jewelry |
| Search Modes | All Metal, Discrimination |
| Audio Tone | 3-Tone Audio Feedback |
To Next Page
