Operation
Flash Output Setting
1.
2. Turn the Rotary Control clockwise to increase the energy level in 1/10 f-stop
increments, and counter-clockwise to decrease. Press and hold down
the Rotary Control while turning to increase or decrease the setting in 1 f-stop
increments.
10
XMS user guide
Operation
Bowens.co.uk
F-STOP
SETTING
10 -
9.0 -
8.0 -
7.0 -
6.0 -
5.0 -
4.0 -
3.0 -
FRACTIONAL
ENERGY
/
/
/
/
/
/
/
/
Modelling Light Mode Setting
Use the LAMP button to select the modelling light:
1. To select proportional modelling, press and hold down the LAMP button
until the PROP Indicator is illuminated. The modelling light intensity
2. To select Free modelling, press and hold down the LAMP button until the
FREE Indicator is illuminated. The last pre-set brightness level of Free
modelling will be used.
3.
4.
Modelling Light Free Setting
To change the level of the FREE modelling light:
1.
set mode).
2.
current FREE value. This will timeout after 8 seconds and revert to FREE.
To Next Page
Loading...
