11
XMS user guide
Operation
Operation
Bowens.co.uk
Modelling Light Free Setting continued.
3. While in FREE set mode, use the turn dial to change the FREE level.
While an adjustment is being made it will stay in the FREE SET mode.
4. Adjust the turn-dial clockwise to increase the FREE level in 1/10 f-stop
increments, and counter-clockwise to decrease. Press and hold down the
turn-dial while turning to increase or decrease the setting in 1 f-stop
increments.
5.
press any button to set FREE mode to the new value.
6. The modelling light intensity is now set to the pre-set FREE value,
Test and Ready Indication
The Ready indicator is extinguished while the unit charges and illuminates when fully
energy is being dumped.
Flash Before Ready
case the unit will display ‘nr’ together with a warbling sound (if warnings are enabled).
under-exposed. The degree of under-exposure depends on when in the recharge cycle
Ready Indication Setting
Use the READY button to select the Ready indication:
1. To select the Ready Beep sound, press and hold down the READY button until the
BEEP Indicator is illuminated. The sounder will beep when the unit has fully
recharged.
2. To select the DIM Indication, press and hold down the READY button until the DIM
Indicator is illuminated. The modelling lamp dims while charging and resumes to the
set brightness when ready. The lamp must be on for this to work.
3. To select the DIM & BEEP Indication, press and hold down the READY button until
both the DIM and BEEP indicators are illuminated.
To Next Page
Loading...
