4
4. Switching On and Off
To switch MH-W on or off slide the power switch.
MH-W will provide audible feedback as it switches
on.
Note: If an MH-W is left switched on but inactive
for more than 20 minutes it will automatically enter
sleep mode to save battery power. It can be woken
by starting a Bluetooth audio stream from a paired
device, by siding the power switch, or pressing the
Bluetooth button.
5. Wearing your MH-W Headphones
Using your headphones correctly will help ensure
that their performance reaches its full potential. First,
identify the left and right ear pieces. Identication
legends are engraved on the metal hinge below the
headband.
This is illustrated in Diagram 3.
Now unfold the headphones and slide them on to
your head with the headband adjusted so that each
ear piece sits comfortably over the ear.
This is illustrated in Diagram 4.
It is recommended that you fold and return your
headphones to their pouch when not in use.
6. Bluetooth Pairing your MH-W
To connect your MH-W to a Bluetooth enabled
audio device it must rst be “paired” with the device.
Once paired, a Bluetooth device and the MH-W
will “remember” each other and be able to connect
when within range.
MH-W can remember up to eight paired Bluetooth
devices. The rst paired device is automatically
designated as the “primary” device. Additional
devices are designated as “secondary” devices.
The primary device will automatically connect when
MH-W is powered on and within range. Secondary
devices will not connect automatically when in
range but must be connected using their Bluetooth
settings menu. When a secondary device is
connected, any other existing secondary connection
will be ended.
At any time, a press of the Bluetooth button will
force MH-W to disconnect all current devices and
connect to the primary device, if it is within range.
It is possible for two devices to be connected to
MH-W simultaneously, however, audio will only be
streamed from one device at any one time.
To pair a Bluetooth device with MH-W follow the
steps described below.
With MH-W switched on, press and hold the
Bluetooth button for 2 seconds. The MH-W indicator
will ash blue and MH-W will provide audible
feedback as it enters “pairing” mode.
Note: MH-W will automatically exit from Bluetooth
pairing mode if no device is paired within 5 minutes.
Open the Bluetooth settings on the source device
and ensure Bluetooth is switched on. Once
discovered, P5 Bowers & Wilkins will appear as
an available Bluetooth device. Select P5 Bowers
& Wilkins and close the Bluetooth settings. The
MH-W Bluetooth indicator will ash continuously
Diagram 3
Identfying left and right
Diagram 4
Adjusting the earpiece.
R
L
To Next Page
Loading...
Need help?
General
Weight and Dimensions
