EasyManuals Logo

Bowers & Wilkins P5 Wireless Manual

Bowers & Wilkins P5 Wireless
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5
ENGLISH
while pairing is underway and blink once in every
4 seconds when pairing is established. MH-W
will also provide audible feedback when pairing is
established.
Note: If your Bluetooth audio source device does not
support “simple” pairing and requests a four digit
code, enter ‘0000’.
Once a connection has been established, ensure
that MH-W is selected as the speaker output for the
Bluetooth source device. Audio will then be heard
through MH-W.
Note: If pairing fails the MH-W indicator will ash
in 2 second bursts. The most common reasons for
pairing failure are signal interference and distance
between the two devices. It is good practice to have
the two devices relatively close to each other when
pairing.
To disconnect a Bluetooth source device from
MH-W press the MH-W Bluetooth button twice in
quick succession. This will disconnect all Bluetooth
connected devices. MH-W will provide audible
feedback when Bluetooth is disconnected.
The MH-W paired device memory can be cleared by
pressing and holding Volume – and Bluetooth button
for 2 seconds. The indicator will ash and MH-W will
restart once its memory has been cleared.
7. Controlling Bluetooth Audio
The MH-W Play/Pause, Volume + and Volume –
buttons can be used to control Bluetooth audio:
Note: The buttons are not operational when the
MH-W is used in passive mode with a wired
connection.
To increase volume press and hold the Vol + button.
To decrease volume press and hold the Vol – button.
To play audio press and release the Play/ Pause
button.
To pause audio press and release the Play/ Pause
button.
To select the next track press the Play/ Pause button
twice in quick succession.
To select the previous track press the Play/ Pause
button three times in quick succession.
8. Using a mobile phone with your MH-W
To answer a call press and release the MH-W Play/
Pause button.
To reject a call press the MH-W Play/Pause button
for 2 seconds.
To end a call press and release the MH-W Play/
Pause button.
A Bluetooth stream playing while a telephone call is
taken will be paused. It will resume when the call is
ended.

Other manuals for Bowers & Wilkins P5 Wireless

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bowers & Wilkins P5 Wireless and is the answer not in the manual?

Bowers & Wilkins P5 Wireless Specifications

General IconGeneral
Impedance22 Ω
Driver unit40 mm
Ear couplingCircumaural
Headphone frequency10 - 20000 Hz
Headphone sensitivity109 dB
Total Harmonic Distortion (THD)0.4 %
Charging sourceUSB
Battery technologyLithium
Battery recharge time3 h
Battery charge indicatorYes
Continuous audio playback time17 h
Product colorBlack
Wearing styleHead-band
Volume controlDigital
Recommended usageCalls/Music
Quantity1
Voice coil typeCCAW
Bluetooth version3.0+HS
Connectivity technologyWired & Wireless
MaterialFoam, Leather, Nylon
Microphone typeBuilt-in
Weight and Dimensions IconWeight and Dimensions
Weight213 g

Related product manuals