Bowflex BXT116 - Page 162

162
5.Usinga13mmwrenchanda6mmhexwrench,removetheindicated
hardware from the Transport Wheel.
6.Usinga13mmwrenchanda6mmhexwrench,attachthenewTrans-
port Wheel to the Frame Assembly.
7.Makesurethereissufcientspacetolowerthewalkingdeck.
Keep a minimum clearance behind the machine of 79” (2 m)
and 24” (0.6 m) on each side. This is the recommended safe
distance for access, movement and emergency dismounts
from the machine.
8. Make sure there is no object on or around the treadmill to spill or cause
blockage from the fully unfolded position.
9. Slightly push the walking deck forward toward the console. Push the
Deck Release Handle until the lift shock releases and you can pull the
walking deck away from the console. Hold up the rear of the walking deck,
and move to the side of the machine.
Keep clear of the movement path of the walking deck.
10. The hydraulic lift is set up to drop gradually. Hold onto the walking
deckuntilapproximately2/3ofthemovementdown.Makesurethatyou
use proper lifting technique; bend your knees and keep your back straight.
Lower the weight with your legs. Be aware that the walking deck can pos-
sibly drop quickly in the last part of the movement.
11. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
Deck Release Handle