51
6. Gently release the front snaps (indicated by ovals) that secure the
Motor Cover and pivot it back toward the walking belt until it releases.
Remove from the machine.
7. Using a #2 Phillips screwdriver, remove the 2 indicated screws from
the Motor Control Board Cover. Lift and remove the Motor Control Board
Cover.
8. From the front, remove the Securing Ring from the Circuit Breaker by
rotating it counter-clockwise. Remove the Circuit Breaker from the Frame.
9. Remove the connectors and attach them to the new Circuit Breaker.
10. Insert the new Circuit Breaker into the Frame and install the Securing
Ring.
Motor Control Board Cover
Circuit Breaker
To Next Page
Loading...
