Bowflex BXT8J - Page 47

47
NOTICE: This document provides instructions for the replacement of the Drive Belt on the Bowex
™
BXT8J / BXT8Ji Treadmills.
If you need assistance, please contact Customer Service (if purchased in US/Canada) or your local distributor (if purchased outside US/Canada). To nd your local dis-
tributor, go to: www.nautilusinternational.com
1. Unplug the power cord from the machine and wait 5 minutes. Place the
power cord in a secure location.
2. Using a #2 Phillips screwdriver remove the 4 indicated screws, and two
additional screws on the far side, from the Motor Cover and remove it.
3. Using a #2 Phillips screwdriver remove the 2 indicated screws from the
MCB Cover and remove it.
4. Using a 6mm hex wrench, remove the indicated screw from the Front
Roller.
!
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power
cord from the wall outlet and wait 5 minutes before cleaning, maintaining or repairing this machine. Place
the power cord in a secure location.
MCB Cover
Front Roller
Motor Cover