6
Step 2.
Some components of the machine can be heavy or awkward. Use a second person when doing the assembly steps involving these parts. Do not do steps that
involve heavy lifting or awkward movements on your own. Lift the Frame Assembly from the exterior of the pivot assembly as indicated below.
NOTICE: Once all hardware has been hand tightened, fully tighten ALL hardware from previous steps. Place the inside hook of the Rear Shroud on the Frame
Assembly and then pivot it up into place.
Item Qty Description Item Qty Description Item Qty Description
3 1 Stabilizer Assembly 5 1 Shroud, Rear 7 1 Stabilizer Shroud, Right
4 4 Leveler 6 1 Stabilizer Shroud, Left 8 2 Cap
8
8
D
E
X4
3
4
6
7
#2
X1
F
5
4
4
4
To Next Page
Loading...
