9
6
*
*
X4
16
17
18
Step 5.
NOTICE: Remove the Rear Console Cover and Hardware from the Console Assembly. Connect the Cables and Place the Console onto the Static Handlebar. With the
Excess of the Cables Pushed into the Static Handlebar, Pivot the Console Assembly Downward and Secure It to the Static Handlebars.
Note: Do not cut or crimp the Cables. Each Cable connector (3-pin, 4-pin, 5-pin and 12-pin) has a corresponding end connector with that many openings. * Hardware is not
supplied on the Hardware Card.
Item Qty Description Item Qty Description Item Qty Description
16 1 Console Assembly 17 1 Console Rear Cover 18 1 Static Handlebar Cap
To Next Page
Loading...
