Step 5. ( for the 552, 560 or 1090 )
Final Inspection
Inspect your equipment to ensure that all fasteners are tight and components are properly assembled.
Do not use or put the equipment into service until the equipment has been fully assembled and inspected for correct performance in
accordance with the User’s Guide. Fully tighten the hardware before you put the dumbbells into the installed dumbbell platforms or
bases on the stand.
Step 4. ( for the 552, 560 or 1090 )
Attach the Retaining Straps to the Stand and Fully Secure each Dumbbell Base
7
7
To Next Page
Loading...
