Boyd S2601 - Page 18

18
SCHM-001
Rev 2
Installation: S2601 & S2605 Upholstery
Back Upholstery – Place the Hangers located near the top of the Back Upholstery into the slots on the Back Frame and slide
upholstery upward until it stops on Hangers. Then, press the Bullets located near the bottom of the upholstery into the Receiving
Clips on the Back Frame. The Back Upholstery Flap attaches to the rear Velcro Strip before installing the Seat Upholstery.
Toe Upholstery – Place the two lower ‘Z’ brackets into the slots located near the bottom of the Toe Frame. Then, press the Bullets
located near the top of the upholstery into the Receiving Clips on the upper part of the Toe Frame. The Toe Upholstery Flap
attaches the front Velcro Strip before installing the Seat Upholstery.
Seat Upholstery – Place the two Angle Brackets near the rear of the Seat Upholstery into open area shown below of Seat Frame.
Lower the upholstery so that the Locking Angle near the front of the upholstery engages tightly into slot at front of Seat Frame.
The angle must be in the slot and not outside of the frame.
Note: Seat Upholstery Brackets can be adjusted as required to reduce any Seat Upholstery movement.
Caution: Move the Seat Upholstery back & forth and side to side to verify that it is securely fastened to the Seat Frame before
operating.
Upholstery Installation and Removal
Rear Velcro for
securing Back Flap
Back Frame
Slots
Back
Upholstery
Upholstery Aachments S2601/S2605
S2601 shown
Seat Upholstery
Toe Upholstery
‘Z’ Brackets
Bullets
Seat Locking Angle
Seat Locang Angles
Toe Flap
Front Velcro for
securing Toe Flap
Receiving Clips
Receiving Clips
Toe Frame
Slots
Back Flap
‘Z’ Brackets
Bullets