BPT UK TRADESMAN TIMER – TT/2
PROGRAMMING
POSSIBLE 6 ON – 6 OFF TIMES OVER 7 DAYS
Hold down both the
PROGRAM
and
CHANGE
buttons until the display blanks, then release.
Display will eventually show as indicated on drawing.
PROGRAMCHANGE
SunMon
0:00
SETTING THE CORRECT DAY & TIME
Press CHANGE button to set day of week MON – SUN
(Indicated by dots left to right as MON – SUN)
Press PROGRAM
Press CHANGE button to set the current hour
Press PROGRAM
Press CHANGE button to set the current minutes
Press PROGRAM
SETTING 1st ON TIME
Press CHANGE until 7 dots appear
(This will enable on time for all 7 days of week, continue pressing CHANGE if you only require
MON-FRI)
Press
PROGRAM
Press CHANGE to set the on time e.g. 6:00
If minutes are not required – press PROGRAM again, otherwise press CHANGE to alter the minutes
Then press PROGRAM
SETTING 1st OFF TIME
Press
CHANGE
to set the off time e.g. 9:00
If minutes are not required – press PROGRAM again, otherwise press CHANGE to alter the minutes
Then press PROGRAM
Set any further ON / OFF times as required.
Note – the day dots can only be set at the on time setting – not the off
After all ON / OFF times are programmed, press PROGRAM until the correct day / time is reached as
previously set.
The display will in any event reset itself to this state after 60 seconds of non-use of push buttons.
To Next Page
Loading...
