INSTALLATION
9834 7-27-07-2
8. Following all standard safety practices, start the skid steer and run all cylinders through
their full cycle to purge any air from the system. Check that all controls function in accor-
dance with the operating control decal.
9. All planers are equipped with a water nozzle kit to adapt them to your existing water line.
Install the female coupler supplied to your existing water line coming from the water tank
on the skid steer. Connect the female coupler to the male coupler on the planer water
nozzle kit. NOTE: There is an optional cab mounted water kit available through your local
dealer.
Your planer is now installed and ready for operation.
DISCONNECT INSTRUCTIONS
1. Center the planer on the sideshift frame.
2. Adjust depth and tilt setting to "0".
3. Set cold planer on a rm level surface.
4. Following Safety Shut Down Procedures; stop the engine and set the parking brake.
Relieve any pressure in the hydraulic lines.
5. Disconnect the power and return hoses from the auxiliary hydraulics. Disconnect the
case drain line. NOTE: It is recommended to disconnect the case drain line last.
6. Disconnect the electrical wire harness from the auxiliary electrical connector or the
BRADCO control handle and after turning the ball valve to the shut off position discon-
nect the water line at the couplers.
7. Following all standard safety practices and the instructions for disconnecting an attach-
ment in your skid steer operator's manual, disconnect the planer from your skid steer al-
lowing the mounting bracket to lower toward the ground as the skid steer is disengaged.
8. Connect the hydraulic couplers on the attachment together to prevent contaminants
from entering the hydraulic system.
To Next Page