Bradco HP400 - Maintenance and Service; Lubrication

MAINTENANCE & SERVICE
9836 7-27-07-2
LUBRICATION
GENERAL INFORMATION
 Economicalandefcientoperationofanymachine
isdependentuponregularandproper
lubricationofallmovingpartswithaqualitylubricant.Neglectleadstoreducedefciency,wear,
breakdownandneedlessreplacementofparts.
 Allpartsprovidedwithgreasettingsshouldbelubricatedasindicated.Ifanygreaset-
tingsaremissing,replacethemimmediately.Cleanallttingsthoroughlybeforeusing
thegrease
gun.
IMPORTANT: Avoid excessive greasing. Dirt collects on exposed grease and greatly in-
creases wear. After greasing, wipe off excessive grease from ttings.
LUBRICATION SYMBOLS
 Thefollowingsymbolsareusedonthelubricationdiagrambelow.Itisreproducedhere
withitsmeaningforyourconvenience.
 Lubricatedailyorevery8hoursofoperation,whichevercomeslast,withSAEMulti-Pur-
poseLubricantorequivalentSAEMulti-Purposetypegrease.
 Lubricateweeklyorevery40houseofoperation,whichevercomeslast,withSAEMulti-
PurposeLubricantorequivalentSAEMulti-Purposetypegrease.
CAUTION! SHUT OFF ENGINE BEFORE LUBRICATING EQUIPMENT.
 Theplanerplanetaryisasealedunit.Ifthereisanysignofoilleakspleasecontactyour
nearestBRADCOdealerbeforecarryingoutanyrepairs,astherecanbeothercausesforseal
leaks.TheplanetaryusestheGearOil(CastrolSP320)forlubricationofgearsandbearings.
Theunitholdsapproximately2quartsofgearoil.
 Theplanetarygear oilshouldbedrainedandreplacedaftertherst8monthsof use.
Thereafterevery12monthsor2500hours-whichevercomesrst.
8
8
40
40
BOTH ENDS
ALL CYLINDERS
ALL WHEEL PINS
40
CHANGE PLANETARY
OIL EVERY 12 MONTHS
OR 2500 HOURS
20
75566