How to fix Bradford White Water Heater when the control LED is not on?
If the control LED is not on or flashing on your Bradford White Water Heater, it could be due to the control power switch being in the “OFF” position or an interruption in the supply voltage. To resolve this, turn the power on.
What to do if my Bradford White RG2PDV40SN Water Heater flashes four times?
If your Bradford White Water Heater shows four flashes with a three-second pause, it could be due to several reasons: the temperature sensor might be out of calibration, the gas control could be faulty, or there might be a plumbing leak. The suggested solution is to replace the gas control.
What does it mean when my Bradford White RG2PDV40SN Water Heater flashes five times?
If your Bradford White Water Heater displays five flashes with a three-second pause, it indicates that the pilot valve is stuck in the open position. The suggested solution is to replace the gas control.
What does three flashes mean on a Bradford White RG2PDV40SN?
If your Bradford White Water Heater shows three flashes with a three-second pause, possible causes include a vent blockage or improper vent configuration, kinked or blocked pressure switch tubing, a faulty pressure switch, the blower not spinning up to speed, the blower or exhaust temperature being too high, or a faulty blower temperature switch.
What causes a 'Six-two flash, three second pause' error on a Bradford White RG2PDV40SN?
If your Bradford White Water Heater is showing a 'Six-two flash, three second pause' error, the possible causes are: vent blockage or improper vent configuration; pressure switch tubing kinked or blocked; faulty pressure switch; vent termination being affected by wind; blower not spinning up to speed; blower temp or exhaust temp too high; or a faulty blower temperature switch. The suggested solution is to check the vent or vent tables.
What does 'Six-three flash, three second pause' mean on my Bradford White Water Heater?
If your Bradford White Water Heater is showing a 'Six-three flash, three second pause' error, the possible causes are: unstable pilot; pilot tube blocked or restricted; oxidation build up on pilot electrode; wire damage to pilot assembly or bad connection at gas valve; insufficient combustion air; gas pressure is out of specification.
What to do for 'Six-four flash, three second pause' on Bradford White RG2PDV40SN?
If your Bradford White Water Heater is showing a 'Six-four flash, three second pause' error, the pilot valve may be stuck in the open position. The suggested solution is to replace the gas control.
Why is my Bradford White RG2PDV40SN showing 'Eight-two flash, three second pause'?
If your Bradford White Water Heater is showing a 'Eight-two flash, three second pause' error, it could be due to damage to the temperature sensor wire or the temperature sensor resistance being out of range. The suggested solution is to replace the gas control.
General| Capacity | 40 gallons |
|---|---|
| Energy Factor | 0.62 |
| Weight | 140 lbs |
| Vent Type | Power Vent |
| Fuel Type | Natural Gas |
| Warranty | 6 years |
| Type | Gas Water Heater |
| Recovery Rate | 40 gallons/hour |
To Next Page