What does 'Head over temp' mean on Brady BMP 61 Label Maker?
If your Brady Label Maker shows a "Head over temp" error, it means the print head is too hot. Allow the print head to cool down for about 10 minutes, then try your print job again.
Why is my Brady BMP 61 Label Maker printing poorly?
If you're getting poor quality prints on your Brady Label Maker, the battery pack may be worn out and not properly holding a charge. Consider ordering a replacement battery pack.
Why is my Brady BMP 61 Label Maker printing with poor quality?
If you're experiencing poor quality printing with your Brady Label Maker, make sure the correct ribbon for the label roll is loaded in the printer.
How to fix 'Ribbon not optimized for label type' error on Brady Label Maker?
If your Brady Label Maker displays an error that the "Ribbon not optimized for label type", the ribbon material type and label material type that are installed in the printer may not be compatible. Replace the ribbon or label supply.
How to fix 'Cover not closed' error on Brady Label Maker?
If your Brady Label Maker displays an error indicating the "Cover not closed", it means the printer cover isn't fully latched. Push down firmly on the cover until you hear it latch, ensuring it lines up evenly with the printer case.
What should I do if my Brady BMP 61 Label Maker shows an error during printing?
If you get an error while printing on your Brady Label Maker, it could be because the printer cover was opened during printing or feeding. Reinstall the ribbon and label supply, and then press the [CLEAR/ESC] key to clear the error.
Why will my Brady Label Maker not feed labels?
If your Brady Label Maker will not feed labels, the leading edge of the label roll may not be inserted far enough or may be uneven. Ensure the leading edge is securely under the ribs, up to the black line. If the edge is torn, use scissors to cut a straight edge.
Why does label material jam in my Brady Label Maker?
If the label material jams in your Brady Label Maker, it might be because the last label wasn't removed. Make sure the last cut label has been removed from the label tray.
What to do if the cutter does not cut on my Brady BMP 61 Label Maker?
If your Brady Label Maker cutter does not cut, it is possibly due to adhesive buildup. Clean the cutter blades using a moistened swab from the cleaning kit.
What to do if my Brady Label Maker says 'Cover not closed'?
If your Brady Label Maker displays 'Error - "Cover not closed"', push down firmly on the cover until you hear it latch. It should line up evenly with the printer case.
General| Print Technology | Thermal Transfer |
|---|---|
| Resolution | 300 dpi |
| Display | Color LCD |
| Cutter | Automatic |
| Keyboard Type | QWERTY |
| Battery | Rechargeable Li-ION battery |
| Max Print Width | 1.5 inches |
| Label Width Range | 0.25 to 1.5 inches |
| Print Speed (mm/s) | 33.8 |
| Connectivity | USB, Wi-Fi |
| Power Source | Battery or AC adapter |
| Supported Materials | Polyester, vinyl, nylon, and more |
| Memory | 256 MB |
| Material Compatibility | Continuous Tapes, Die-Cut Labels |
To Next Page
