Brainchild BTC-9300 - Programming Port

2 18 Programming Port2 18 Programming Port
See Figure 1.3 in Section 1-3 to find the programming port location.See Figure 1.3 in Section 1-3 to find the programming port location.
The programming port is used for off-line automatic setup and testing procedures only.
Don't attempt to make any connection to these jumpers when the unit is used for a
normal control purpose.
The programming port is used for off-line automatic setup and testing procedures only.
Don't
attempt to make any connection to these jumpers when the unit is used for a
normal
control purpose.
Switch Unit
DMM
Calibrator
SW6400
HP 34401A
HP 34401A
Fluke 5520AFluke 5520A
UM93001C
NOTE
39
Figure 2.23 Programming
Port Wiring
Figure 2.23 Programming
Port
Wiring
Programmer
connector and
ATE connector
inserted here
Programmer
connector
and
ATE
connector
inserted
here
Access hole
on the
bottom view
Access hole
on
the
bottom
view
INPT1
Programmer
P10A
Programmer
P10A
1
ON DIP
234