The service book IV / ALFA 11 03-9940.186
Mounting instructions:
Electrical devices
Individual kit components are electrically connected by connecting beam. Connection and cuts cable for
vehicle networks must conform to the schema of el. installation (see Chapter XI of the electrical network of
heater). Electric installation of heater is doable wire. Control is placed inside the cabin so that could be in
operator´s reach and in his visual field.
At assembly it shall be abide with wire cross sections given below in the table to avoid voltage depression.
The difference between the voltage at the battery and voltage of the heater mustn't be higher than 0.3 V
To Next Page
