The service book IV / ALFA 15 03-9940.186
9. Screw the glow plug.
10. Connect all harnesses to the control unit and connect overheating fuse.
11. Insert the heater into the bottom cover while the harness grommet is placed into the notch in the
cover. Next, put on the back cover and the top cover press down the bottom, so as to capture both
clips.
12. Fit the girds.
13. Refit the exchanger seal.
THE PROCEDURE FOR RESOLVING COMPLAINTS
If there is a defect within the warranty period must be observed following procedure, otherwise entitled to
claim lapses, as stated in the warranty certificate.
1. A customer who is claiming the heater, submits a warranty certificate, which is filled at all points (a
type of heater, date of manufacture, serial number, date of sale, installation performed, the type and
brand of car, the name and address of the customer).
2. The service repairs the heater and replaces the defective parts.
3. The service duly completes the complaint protocol, which specifies the type of defect and the method
of its removal. Service sends it together with a copy of the warranty certificate and defective parts to
the address BRANOMARKET s.r.o.; Račanech 100, Jilemnice 514 01.
The credit note will be sent to the contracting service after evaluation of the complaint. On the basis of it
the contracting service issues an invoice and send it to the address of the service BRANO, a.s., Na
Račanech 100, Jilemnice 514 01.
Amount of the credit will be equal to the work identified in the claim report and will respond time standards,
which are integral parts of the service representation
FILLING WARRANTY CERTIFICATE
Following items are completed from BRANO a.s. manufacturer's plant:
Heating type – 12V (24V)
Day of manufacture
Serial Number
Output QC certificate
The following items will be fulfilled by a service person:
Date of sale
Vehicle brand & type
Name & address or the customer
Assembled to the vehicle by ( name service, address, stamp, date, signature)
The customer will acknowledge taking over the Warranty by signature in Customer's signature cell.
The warranty certificate remains with the customer. The service sends an electronic copy of the warranty
certificate (* .pdf or * .jpg) to a service support as Brano on the e-mail reklamacent@brano.eu.
MEASURING INSTRUMENTS
For diagnostics and service of the independent air heater BREEZE IV, WIND IV a ATESO ALFA it is
necessary that the service was equipped with these meters and instruments: the program LIN-bus and the
tester of underpressure of air discharge
The tester of underpressure of air discharge
To Next Page
