13 Operating Your Cleaner
Cleaning Items
NOTE: Select Set Time then press ON/OFF once to stop ultrasonics at
any time.
Step Action
1 Place the items into a basket, perforated tray, or beakers in a
positioning cover.
2 If using beakers or a solid tray, add cleaning solution to
beakers or tray to cover the items.
3
Slowly lower the tray or beakers into the tank. Do not stir.
4 Press ON/OFF once to activate ultrasonics.
5 When the items are clean, press ON/OFF once to deactivate
ultrasonics, then slowly remove the items from the cleaner.
6 Rinse clean items with clean, warm water and dry, if
necessary.
CAUTION
• Do not place parts or containers directly on the bottom of the cleaning
tank; use a tray or wire to suspend items.
• Do not allow the solution to drop more than 3/8 inch below the
operating level line with the cleaner on.
• Do not ever use alcohol, gasoline or flammable solutions. Doing so
could cause a fire or explosion. Use only water-based solutions.
• Do not ever use mineral acids. These could damage the tank.
Failure to comply with these cautions will void your warranty.
To Next Page
Loading...
